Hyundai Equus: Battery Sensor Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Electrical System / Charging System / Battery Sensor Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Electrical System / Charging System / Battery Sensor Repair procedures
| Removal |
| 1. |
Disconnect the battery negative (-) cable. |
| 2. |
Disconnect the battery sensor connector (A). |
| 3. |
Remove the battery negative (-) cable after removing the bolts (B).
|
| Installation |
| 1. |
Install in the reverse order of removal.
|
Battery Sensor Description and Operation
Description
Vehicles have many control units that use more electricity.
These units control their own system based on information from diverse
sensors. It is important to have a stable power s ...
Starting System
...
See also:
Description and Operation
Description
The hydraulic system consists of oil, an oil filter, an oil pump, and a valve body (valves and solenoid valves).
The oil pump is powered by the engine. ATF passes through the oil filt ...
Engine Control Module (ECM) Repair procedures
Removal
When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below.
[In the case of installing used ECM]
1) Perform "ECM Neutra ...
Fuel Filler Door Open Switch Repair procedures
Inspection
1.
Remove the front door trim panel.
(Refer to BD group - "Front door")
2.
Check the switch (A) for continuity between the terminals.
3.
If the continuity is not as specified, ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com