>

Hyundai Equus: Alternator Description and Operation - Charging System - Engine Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Alternator Description and Operation

Description
The Alternator has eight built-in diodes, each rectifying AC current to DC current.
Therefore, DC current appears at alternator "B" terminal.
In addition, the charging voltage of this alternator is regulated by the battery voltage detection system.
The alternator is regulated by the battery voltage detection system.
The main components of the alternator are the rotor, stator, rectifier, capacitor brushes, bearings and V-ribbed belt pulley.
The brush holder contains a built-in electronic voltage regulator.

1. Brush
2. Drive belt pulley
3. Rotor
4. Stator

    Repair procedures
    On-vehicle Inpection     • First of all, check for DTCs. If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DTC guide) ...

    Alternator Specifications
    Specification ItemSpecificationRated voltage13.5V , 180ASpeed in use1,000 ~ 18,000rpmVoltage regulatorIC Regulator built in type Regulator reform mode voltage (V) [COM terminal]13.85 ~ 14.85 (-35 ...

    See also:

    4&OD Clutch Control Solenoid Valve Repair procedures
    Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

    Smart Key Unit Components and Components Location
    Components Connector Pin Information No.Connector AConnector BConnector C1V_BAT loadC_CAN LowSSB illumination ground2-C_CAN High-3Power ground1-SSB LED OFF4IGN1-Interior antenna #2 power5IGN1 rela ...

    Base curb weight
    This is the weight of the vehicle including a full tank of fuel and all standard equipment. It does not include passengers, cargo, or optional equipment. ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com