Hyundai Equus: Oil Pressure Switch Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Mechanical System / Lubrication System / Oil Pressure Switch Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Mechanical System / Lubrication System / Oil Pressure Switch Repair procedures
| Inspection |
| 1. |
Check the continuity between the terminal and the body with an ohmmeter.
If there is no continuity, replace the oil pressure switch.
|
| 2. |
Check the continuity between the terminal and the body when
the fine wire is pushed. If there is continuity even when the fine wire
is pushed, replace the switch.
|
| 3. |
If there is no continuity when a 49.0kPa (0.5kg/cmx, 7.1psi)
is applied through the oil hole, the switch is operating properly.
Check for air leakage. If air leaks, the diaphragm is broken. Replace
it. |
Oil Pump Repair procedures
Removal
1.
Remove the sub frame.
(Refer to SS group)
2.
Drain engine oil.
(1)
Remove the oil filler cap.
(2)
After lifting the car, remove the oil drain plug and drain oil into a conta ...
See also:
Oil Pump Repair procedures
Removal
1.
Remove the sub frame.
(Refer to SS group)
2.
Drain engine oil.
(1)
Remove the oil filler cap.
(2)
After lifting the car, remove the oil drain plug and drain oil into a conta ...
Sunroof Sunshade Repair procedures
Replacement
1.
Remove the sunroof assembly.
(Refer to Sunroof - "Sunroof Assembly")
2.
After loosening the mounting screw, then remove the drip link (A) and sunshade stopper (B).
3.
Remov ...
Fuel Tank Air Filter Repair procedures
Replacement
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the service cover (A).
3.
Disconnect the canister close valve connector (A).
4.
Di ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com