>
1. Remove the rear seat
5 Seater
1.Disconnect the negative battery cable.
2.Remove the rear seat cushion.
3.Loosen the mounting bolts, then remove the rear seat back.
4.Disconnect the connector.
5.Push the hook, disconnect the main connector.
Tightening torque :
34.3~53.9 N.m
3.5~5.5 kgf.m,
25.3~39.8 lb-ft
6.Loosen the mounting bolts, then disconnect the connector.
7.Remove the side seat.
4 Seater
1.Disconnect the negative battery cable.
2.Remove the rear seat cushion.
3.Loosen the mounting bolts, then remove the rear seat back.
Tightening torque :
34.3~53.9 N.m
3.5~5.5 kgf.m,
25.3~39.8 lb-ft
4.Disconnect the connectors and hose.
2. Remove the rear package tray trim
1.Remove the rear door scuff trim.
2.Loosen the mounting screw, then remove the rear wheel house trim.
3.Remove the cap, then loosen the mounting screw.
4.Remove the rear pillar trim.
5.Push the hook, remove the rear seat belt cover.
6.Remove the rear seat belt lower anchor.
Tightening torque : 39.2~53.9 N.m
4.0~5.5 kgf.m
28.9~39.8 lb-ft
7.Loosen the mounting screws, then remove the package tray trim.
3. Replace the high mounted stop light
1.Remove the high mounted stop lamp after removing screws.
2.Install a new light.
4. Installation
Install in the reverse order of removal.
Cylinder Block Repair procedures
Disassembly
Engine removal is required for this procedure.
•
Use fender covers to avoid damaging painted surfaces.
•
To avoid damage, unplug the wiring connectors ca ...
Room Lamp Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Detach the lamp lens and reflector (A) from the room lamp with a flat-tip screwdriver.
3.
Remove the room lamp (A) after removin ...
Overview
Description
The trip computer is a microcomputer- controlled driver information system that
displays information related to driving.
✽ NOTICE
Some driving information stored in the trip co ...