>

Hyundai Equus: Detecting sensor - Blind spot detection system (BSD) (If equipped) - Driving your vehicle - Hyundai Equus 2009-2026 Owners ManualHyundai Equus: Detecting sensor

The sensors are located inside of the rear bumper.


The sensors are located inside of the rear bumper.

Always keep the rear bumper clean for the system to work properly.

    Warning type
    The system will activate when: 1.The system is on 2.Vehicle speed is above 9.3 mph (15 km/h) 3.Other vehicles are detected in the rear side If a vehicle is detected within the boundary of the ...

    Warning message
    If the detecting sensor performance is low or overheated by foreign substances on the rear bumper, the message will appear to notify the driver. Also, the message may appear when there is heavy ...

    See also:

    Air Spring Description and Operation
    Description Because of the design layout, the air spring and the shock absorber (damper) is separated. The average (target) pressure of rear air spring for normal operation is around 8.5 bar. ...

    Front Wheel Guard Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply p ...

    Power Trunk Module Drive Unit Schematic Diagrams
    Circuit Diagram ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com