>
To operate the LDWS, pull the switch with the Engine Start/Stop Button in the ON position. The indicator illuminates on the cluster. To cancel the LDWS, pull the switch again.
LDWS indicator light illuminates:
If your vehicle leaves the lane when the LDWS is operating and vehicle speed exceeds 43 mph (70 km/h), the warning operates as follows:
1. Visual warning
If you leave the lane, the lane you leave on the LCD display blinks yellow.
2. Auditory warning
If you leave the lane, the warning sound operates.
3. Tactual warning (if equipped with pre-safe seat belt)
If you leave the lane for about 3 seconds, the pre-safe seat belt provides haptic warning.
You can activate or deactivate this feature. Refer to "User Settings Mode" in chapter 4.
The LDWS does not operate when:
✽ NOTICE
To change lanes, operate the turn signal switch then change the lane.
Front Stabilizer Bar Repair procedures
Replacement
1.
Removal the front wheel & tire.
Tightening torque :
90.0 ~ 110.0 N.m(9.0 ~ 11.0 kgf.m, 65.0 ~ 80.0 lb-ft)
2.
Disconnect the stabilizer link (A) from the front strut a ...
Driver Airbag (DAB) Module and Clock Spring Description and Operation
Description
The Driver Airbag (DAB) is installed in the steering wheel
and electrically connected to SRSCM via the clock spring. It protects
the driver by deploying the airbag when frontal cras ...
Knee Airbag (KAB) Module Repair procedures
Removal
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
...