The driver must be cautious in the below situations for the system may not assist
the driver and may not work properly.
- The lane is not visible due to snow, rain, stain, a puddle or many other
things.
- The brightness of the outside changes suddenly such as passing through a
tunnel.
- Not turning on the headlight or the light is weak even at night or in a
tunnel.
- Difficult to distinguish the color of the lane marker from the road.
- Driving on a steep grade or a curve.
- Light reflects from the water on the road such as sunlight, streetlight
or the light of oncoming vehicles.
- The lens or windshield is stained with foreign matters.
- The sensor cannot detect the lane because of fog, heavy rain or heavy snow.
- The surrounding of the inside rear view mirror temperature is high due to
direct light.
- The lane is very wide or narrow.
- The lane marker is damaged or indistinct.
- The shadow is on the lane marker by a median strip.
- There is a mark similar to a lane marker.
- There is a boundary structure.
- The distance from vehicle ahead is very short or the vehicle ahead drives
hiding the lane marker.
- The vehicle shakes heavily.
- The lane number increases or decreases or the lane marker are crossing complicatedly.
- Placing something on the dashboard.
- Driving with the sun in front of you.
- Driving in areas under construction.
- The lane marker is more than two.
- The lane marker in a tunnel is hard to distinguish due to dust or grease.
- The lane marker is hard to distinguish after raining at night.
- The lane marker is hard to distinguish due to dust.
To operate the LDWS, pull the switch with the Engine Start/Stop Button in the
ON position. The indicator illuminates on the cluster. To cancel the LDWS, pull
the switch again.
LDWS indicator li ...
AVSM detects the distance from the vehicle ahead with the sensor, to warn you
before collision and protect you in certain hazardous situations by using warning
message, warning sound and seat belt ...
See also:
Lighting control
The light switch has a Headlight and a Parking light position.
To operate the lights, turn the knob at the end of the control lever to one of
the following positions:
(1) OFF position
(2) Aut ...
Center Control Panel (CCP) Repair procedures
Removal
Front Keyboard Unit
1.
Disconnect the negative (-) battery terminal.
2.
Remove the floor console upper cover.
(Refer to Body - "Floor console assembly")
3.
Disconnect the connect ...
Check battery and cables
Winter puts additional burdens on the battery system. Visually inspect the battery
and cables as described in section 7. The level of charge in your battery can be
checked by an authorized EQUUS d ...