
(1) Front map lamp
(2) Front room lamp
- •
: Press the button
to turn the map lamp on. This light produces a spot beam for convenient use
as a map lamp at night or as a personal lamp for the driver and the front passenger.
To turn the lamp off, press the button again.
- • DOOR : The front and rear room lamps come on for approximately
30 seconds when doors are unlocked with the smart key as long as the doors are
not opened. When the Engine Start/ Stop Button is in the ACC or OFF position,
if any door is opened, the front or rear room lamp will stay on for approximately
20 minutes. If the door is closed, the lamps will go out in 30 seconds. The
front and rear room lamps will go out immediately if the Engine Start/ Stop
Button is changed to the ON position with all doors closed. When the Engine
Start/Stop Button is in the ON position, if any door is opened, the front or
rear room lamp will stay on continuously. If the door is closed, the lamp will
go out immediately.
- ROOM : Pressing the button, turns the front and rear room lamps on. To turn
the lamps off, press the ROOM button again.
CAUTION
Do not use the interior lights for extended periods when the engine is not
running. It may cause battery discharge.
WARNING
Do not use the interior lights when driving in the dark. Accide ...
(1) Rear map lamp
(2) Rear room lamp
: Press the button to turn
the rear lamp on. To turn the lamp off, press the button again.
• ROOM : Pressing the button, turns the rear room lamps on ...
See also:
Seat belt restraint system
WARNING
For maximum restraint system protection, the seat belts must always be
used whenever the car is moving.
Seat belts are most effective when seatbacks are in the upright position.
Chi ...
Fuel Pump Control Module (FPCM) Description and Operation
Description
The fuel pump control module (FPCM) is installed on the right
side of the trunk compartment. It controls the BLDC (Brushless DC)
motor mounted inside the variable low pressure fuel ...
Temperature Control Actuator Description and Operation
Description
The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows.
The signal from the control unit adjusts the position of the ...