>

Hyundai Equus: Ambient Temperature Sensor Repair procedures - Air Conditioning System - Heating, Ventilation and Air Conditioning - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: Ambient Temperature Sensor Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Remove the front bumper.
(Refer to Body - "Front Bumper Cover")
3.
Disconnect ambient temperature sensor.
4.
Check the resistance of the ambient temperature sensor between terminals 1 and 2 whether it changes by changing the ambient temperature.

1. Ambient Sensor (+)

2. Ambient Sensor (-)

Specification
Ambient temperature
[°C(°F)]
Resistance between terminal 1 and 2 (kx)
-30 (-22)
480.41
-20 (-4)
271.21
-10 (14)
158.18
0 (32)
95.1
10 (50)
58.8
20 (68)
37.32
30 (86)
23.26
40 (104)
16.13
50 (122)
10.95

5.
If the measured resistance is not within specification, substitute with a known-good ambient temperature sensor and check for proper operation.
6.
Replace the ambient temperature sensor if it is proved that there is a problem with the sensor.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front bumper.
(Refer to Body - "Front Bumper Cover")
3.
Disconnect the smart cruise control unit connector (A).
4.
Loosen the bolts and then remove the smart cruise control unit bracket (B).

5.
Disconnect the connector and then remove the ambient temperature sensor (A).
[Smart Cruise Control system]

[Non-Smart Cruise Control system]

6.
Install in the reverse order of removal.
    Ambient Temperature Sensor Description and Operation
    Description The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower te ...

    Air Quality Sensor (AQS) Description and Operation
    Desciption The Air Quality Sensor (AQS) is located at the center support in front of the engine radiator. It detects hazardous elements in ambient air providing output signal to the control. A ...

    See also:

    Rear Door Window Glass Repair procedures
    Replacement 1. Pull down rear door window glass by pressing the power window glass switch. 2. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 3. After loosening the mo ...

    Exhaust Manifold Components and Components Location
    Components 1. Exhaust manifold heat protector2. Exhaust manifold3. Exhaust manifold gasket4. Exhaust manifold stay ...

    Camshaft Position Sensor (CMPS) Troubleshooting
    Signal Waveform This example shows a typical Crankshaft Position Sensor (CKPS) and Camshaft Position Sensor (CMPS) waveform at idle. ...

    Categories

    Hyundai Equus Manuals

    © 2011-2025 Copyright www.heqmanual.com