Hyundai Equus: Blind Spot Detection Indicator Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Blind Spot Detecation system / Blind Spot Detection Indicator Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Blind Spot Detecation system / Blind Spot Detection Indicator Repair procedures
| Removal |
Blind Spot Detection Warnig Indicator
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the mirro (A).
|
| Installation |
Blind Spot Detection Warnig Indicator
| 1. |
Install the outside mirror. |
| 2. |
Connect the negative (-) battery terminal. |
| Inspection |
| 1. |
Verify that the mirror operates properly as shown in the below table.
BSD warning lamp
|
Troubleshooting
Troubleshooting
Examples of False-Alarm Occurrence from system characteristics (It’s not a problem)
-
Characteristics of EM Wave : EM Waves are reflected against
all material and especially ...
See also:
Power Mosfet Repair procedures
Inspection
1.
Turn the ignition switch ON.
2.
Manually operate the control switch and measure the voltage of the blower motor.
3.
Select the control switch to raise the voltage until high ...
Schematic Diagrams
Schematic Diagram
...
Side impact air bag
Your vehicle is equipped with a side impact air bag in each front and outboard
rear seat. The purpose of the air bag is to provide the vehicle's driver and/or
the front and outboard rear pas ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com