Hyundai Equus: Blind Spot Detection Switch Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Blind Spot Detecation system / Blind Spot Detection Switch Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Blind Spot Detecation system / Blind Spot Detection Switch Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery. |
| 2. |
Remove the crash pad lower panel (A).
(Refer to Body - "Crash Pad Lower Panel") |
| 3. |
Remove the crash pad lower panel and then push the blind spot detection switch (A) to remove it.
|
| Installation |
| 1. |
Install the blind spot detection switch after connecting the connector. |
| 2. |
Install the crash pad lower panel. |
| Inspection |
| 1. |
Disconnect the BSD switch connector.
|
| 2. |
Operate the BSD switch, then check for continuity between terminals of BSD switch connector.
|
See also:
Repair procedures
Fuel Pressure Test
1.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line")
When removing the fuel pump re ...
Rear Wheel House Trim Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply pr ...
Fuel Sender Assembly Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
"Release the residual pressure in fuel line.
(Refer to Fuel Delivery System -""Release Residual Pres ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com