>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
3. |
Remove the crash pad lower panel and then push the rear parking assist switch (A) to remove it.
|
Installation |
1. |
Install the rear parking assist switch after connecting the connector. |
2. |
Install the crash pad lower panel. |
Inspection |
1. |
Check that continuity exists between the terminals. If there is no continuity, replace the seat heater switch. |
Specifications
Specifications
DescriptionSpecificationsLimitGeneralTypeV-type, DOHCNumber of cylinders8Bore96mm (3.7795in)Stroke87mm (3.4252in)Total displacement5.038 cc (307.3 cu.in)Compression ratio11.5 : 1Fi ...
Tire care
For proper maintenance, safety, and maximum fuel economy, you must always maintain
recommended tire inflation pressures and stay within the load limits and weight
distribution recommended for your ...
Blind spot detection system (BSD) (If equipped)
The BSD (Blind spot detection) system uses a radar sensor to alert the driver
while driving.
It senses the rear side territory of the vehicle and provides information to
the driver.
(1) BSD (B ...