>
Hyundai Equus Manuals

Hyundai Equus: Schematic Diagrams - Multi-view Camera System - Body Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Schematic Diagrams

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Multi-view Camera System / Schematic Diagrams

Circuit Diagram

Multi-view Camera System Input/Output
1.
Camera input
Item
Specification
Lens angle of view
190 degrees
Angle of view
Horizontal
186 degrees
Vertical
135 degrees
Function
Provides the original image of the wide angle image
(no additional function)
Application location
Same camera applied to the front, rear, left and right

2.
Multi-view Camera image output
The Multi-view Camera unit carries out distortion compensation and video merging on the image from 4 cameras installed around the vehicle, indicates steering interlocking guidelines and others, and outputs them in analog.
3.
Multi-view Camera switch
When the switch is ON, this is used as a control input signal that operates the front view mode.
4.
Ignition input
The Multi-view Camera unit outputs images only when IGN2 ON. When IGN2 OFF , it is an Multi-view Camera OFF state, and limits image outputting.
Multi-view Camera unit uses signals inputted through IGN pin or M_CAN communication to determine whether IGN2 is ON or OFF.
5.
Output switch indicator lamp
Multi-view Camera units output power through PWM waves from the LED located in the Multi-view Camera switch to show the user whether the switch has been pressed.
6.
Input chassis CAN (C_CAN)
The Multi-view Camera unit uses C_CAN to receive information about the vehicle's condition and to decide whether to carry out main Multi-view Camera operations.
7.
Multimedia CAN input/output (M_CAN)
The Multi-view Camera unit uses the AVN, which displays images from the Multi-view Camera, and M_CAN to communicate to send and receive the following information.
A.
Send Multi-view Camera mode conversion requests for Multi-view Camera output images (e.g. Navi mode> Multi-view Camera mode)
B.
Send requests for user Multi-view Camera view conversion
C.
Send compensation coordinates for tolerance compensation
D.
Send warning messages to be indicated in the AVN
E.
Send any user option changes
    Description and Operation
    Description Multi-view Camera System is the system that allows video monitoring of 360 degrees around the vehicle. The system includes 4 ultra optical camera mounted around the vehicle (front, ...

    Repair procedures
    Inspection Tolerance Compensation Tolerance compensation compensates for the error margins of Multi-view video that occur due to the installation tolerance when the four cameras that comprise ...

    See also:

    Recommended SAE viscosity number
    CAUTION Always be sure to clean the area around any filler plug, drain plug, or dipstick before checking or draining any lubricant. This is especially important in dusty or sandy areas and when t ...

    Hill-start assist control (HAC)
    A vehicle has the tendency to roll back on a steep hill when the driver begins to accelerate after a stop. The Hill-start Assist Control (HAC) prevents the vehicle from rolling back by operating t ...

    Inhibitor Switch Description and Operation
    Description Inhibitor Switch monitors the lever's position(PRND) and is used to control gear setting signals. ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com