>

Hyundai Equus: Power Striker Repair procedures - Power Trunk Module - Body Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Power Striker Repair procedures

Inspection
Power Trunk Lid Inspection With GDS
1.
Check the power trunk module input/output value by using the GDS. If the operation of power trunk module is abnormal, replace power trunk drive unit.
2.
To check the DTC of the power trunk module, select "PTM"
3.
Select "Input/output monitoring".

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the trunk trim in the trunk.
(Refer to Body - "Trunk")
3.
Disconnect the power striker connector (A).

4.
Remove the power striker (A) after removing the screws.

Installation
1.
Install the power striker and connector.
2.
Install the trunk trim.
3.
Connect the negative (-) battery terminal and check the power trunk module correctly.
    Power Latch Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the trunk trim in the trunk. (Refer to Body - "Trunk") 3. Remove the power latch (A) after removing the bolts (2EA) and ...

    Windshield Wiper/Washer
    ...

    See also:

    Master Cylinder Repair procedures
    Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the cover. 3. Disconnect the ECM connector (A) and TCM connector (B). And then take the protect ...

    Steering wheel audio control
    The steering wheel may incorporate the audio control buttons. CAUTION Do not operate audio remote control buttons simultaneously. VOLUME (VOL + / - ) (1) Press the up button (+) to increase ...

    Components and Components Location
    Component Location 1. Rear curtain2. Rear curtain switch (Floor console upper cover)3. Body Control Module (BCM)4. Rear seat curtain switch5. Rear door curtain6. Rear door module ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com