>
Inspection |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the rear glass defogger relay (A) from the engine room relay box. |
3. |
There should be continuity between the No.87 and No.30
terminals when power and ground are connected to the No.86 and No.85 in
the relay. |
4. |
There should be no continuity between the No.87 and No.30 terminals when power is disconnected. |
Side Sill Molding Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply prote ...
Oil Pump Repair procedures
Removal
1.
Remove the sub frame.
(Refer to SS group)
2.
Drain engine oil.
(1)
Remove the oil filler cap.
(2)
After lifting the car, remove the oil drain plug and drain oil into a conta ...
Fuse/relay panel description
Inside the fuse/relay panel covers, you can find the fuse/relay label describing
fuse/relay name and capacity.
✽ NOTICE
Not all fuse panel descriptions in this manual may be applicable to ...