Hyundai Equus: Power Seat Motor Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Seat Electrical / Power Seat Motor Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Seat Electrical / Power Seat Motor Repair procedures
| Inspection |
Slide Motor Limit Switch
| 1. |
Disconnect the limit switch (A) and operate the limit switch. |
| 2. |
Check for continuity between the terminals. |
| 3. |
Make sure that the seat operation is normal in the reverse after the maximum operation. |
| 4. |
If there is an abnormality, replace the limit switch.
|
Reclining Motor Limit Switch
| 1. |
Disconnect the limit switch and operate the limit switch. |
| 2. |
Check for continuity between the terminals. |
| 3. |
Make sure that the seat operation is normal in the reverse after the maximum operation. |
| 4. |
If there is an abnormality, replace the limit switch.
|
Power Seat Motor
| 1. |
Disconnect the connectors for each motor.
|
| 2. |
With the battery connected directly to the motor terminals, check if the motors run smoothly. |
| 3. |
Reverse the connections and check that the motor turns in reverse. |
| 4. |
If there is an abnormality, replace the motors.
[Driver (IMS)]
[Assist (Limousine 5:5 Option)]
[Assist (Except For Limousine 5:5 Option)]
[Rear Assist]
|
Components and Components Location
Component Location
1. Slide motor2. Front Height motor3. Rear Height motor4. Recline motor5. Headrest motor6. Cushion extension motor7. Air lumbar support switch8. Air lumbar support pump9. Air l ...
Air Lumber Support Switch Repair procedures
Inspection
1.
Disconnect the negative(-) battery terminal.
2.
Remove the shield outer cover.
(Refer to Body - "Front Seat Shield Outer Cover")
3.
Disconnect the power seat air lumber supp ...
See also:
Winter driving
More severe weather conditions of winter result in greater wear and other problems.
To minimize winter driving problem, you should follow these suggestions: ...
Compressor Description and Operation
Description
The compressor is the power unit of the A/C system.
It is located on the side of engine block and driven by a V-belt of the engine.
The compressor changes low pressure and low tempera ...
Hazard Lamp Switch Repair procedures
Inspection
1.
Check "IPM" input/output specification of hazard lamp switch
using the GDS. If the specification is abnormal, replace the hazard
switch module.
2.
Select option "Input/output ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com