>
Hyundai Equus Manuals

Hyundai Equus: Repair procedures - Multifunction Switch - Body Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Multifunction Switch / Repair procedures

Removal
1.
Remove the steering column upper and lower shrouds after loosening screws.

2.
Disconnect the multifunction switch connector (A).

3.
Remove the wiper & washer switch (A) by pushing the lock pin.
   
When removing the wiper & washer switch only, release the lock of wiper switch without removing the steering wheel.

4.
Remove the clock spring.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")

5.
Loosen the screws (2EA) from the multifunction switch assembly (A).

Installation
1.
Install the multifunction switch after connecting the connector.
2.
Install the clock spring.
   
-
Set the center position by setting the marks between the clock spring and the cover into line.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
3.
Install the steering column upper and lower shrouds.
4.
Install the steering wheel.
   
Make sure the multifunction switch connectors are plugged in properly.
Inspection
1.
Check input/output specification of multifunction switch using the GDS. If the specification is abnormal, replace the lamp or wiper switch.
2.
If diagnosis is required on the multifunction switch, select model and "BCM".
3.
Select "Current data" and check the input/output condition of "Multifunction switch".

    Description and Operation
    Description     Refer to the "Body Network System" for the abbreviation information. ...

    Horn
    ...

    See also:

    Recommended cold tire inflation pressures
    All tire pressures (including the spare) should be checked when the tires are cold. “Cold Tires” means the vehicle has not been driven for at least three hours or driven less than one mile (1. ...

    Power Steering Hose Repair procedures
    Replacement - Refer to the components illustration during removal or installation. - When installing, be sure to connect between hose to tube using a clamp as shown in the illustration. - ...

    Front Impact Sensor (FIS) Description and Operation
    Description The front impact sensor (FIS) is installed in the Front End Module (FEM). They are remote sensors that detect acceleration due to a collision at its mounting location. The primary p ...

    Categories

    Hyundai Equus Manuals

    2011-2026 Copyright www.heqmanual.com