>

Hyundai Equus: Front Seat Belt Pretensioner Repair procedures - Front Seat Belt - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Front Seat Belt Pretensioner Repair procedures

Replacement
   
•
When installing the belt, make sure not to damage the pretensioner.
1.
Remove the safety belt (A) by turning it in the direction of arrow using a flat-head screwdriver.

2.
Remove the center pillar lower trim.
(Refer to Interior Trim - "Center Pillar Trim")
3.
Remove the center pillar upper trim.
(Refer to Interior Trim - "Center Pillar Trim")
4.
After loosening the mounting bolt, then remove the front seat belt lower anchor (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

5.
Loosen the front seat belt webbing guide (A) mounting bolts.

6.
After disconnecting the pretensioner connector lock pin, remove the front seat belt pretensioner connectors (A), loosen the mounting bolts, then remove the front seat belt pretensioner (B).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

7.
Install in the reverse order of removal.
   
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips.
    Front Seat Belt Pretensioner Components and Components Location
    Component Location 1. Front seat belt pretensioner ...

    Height Adjust Components and Components Location
    Component Location 1. Height adjust ...

    See also:

    Repair procedures
    On-vehicle Inpection     • First of all, check for DTCs. If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DTC guide) ...

    Rear Wheel House Trim Components and Components Location
    Component Location 1. Rear wheel house trim ...

    Sedan Rear Body
    Rear body Roof panel rear cornerSide outer panel rear cornerRear parkage tray panel tooling hole(O23)Side outer panel rear cornerTooling hole (14X10)Tooling hole (O10) ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com