>
Hyundai Equus Manuals

Hyundai Equus: Front Seat Cushion Cover Repair procedures - Front Seat - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Front Seat Cushion Cover Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Cushion Cover Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
2.
Remove the front seat rear shield outer cover.
(Refer to Front Seat - "Front Seat Shield Outer Cover")
3.
Remove the front seat shield inner cover.
(Refer to Front Seat - "Front Seat Shield Inner Cover")
4.
Disconnect the front seat under lamp connector (A).

5.
Pull out the protecter (A), and then front seat cushion cover (C) from the front seat cushion frame (B).

6.
Remove the front seat cushion cover (A) from the front seat cushion frame.

7.
After removing the hog-ring clips on the front of seat cushion and remove the front seat cushion cover (A).

8.
Install in the reverse order of removal.
   
•
To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).
•
Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).

    Front Seat Cushion Cover Components and Components Location
    Component Location 1. Front seat cushion cover ...

    Front Seat Frame Assembly Components and Components Location
    Component Location 1. Front seat back frame assembly2. Front seat cushion frame assembly ...

    See also:

    Head Lamps Repair procedures
    Inspection Head Lamp Relay Inspection 1. Pull out the head lamp relay (Low) (A) from the engine compartment relay box. A : Head lamp(Low) relay 2. Check for continuity between terminals. The ...

    PGS Unit (Back & Blinde Unit) Components and Components Location
    Components ...

    Intake Manifold Repair procedures
    Removal and Installation 1. Disconnect the negative terminal (A) from the battery. Tightening torque : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft) 2. Remove the engine room cover (A ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com