>
Hyundai Equus Manuals

Hyundai Equus: Rear Seat Frame Assembly Repair procedures - Rear Seat - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Rear Seat Frame Assembly Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Seat Frame Assembly Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Disconnect the rear seat frame mounting connector (A).
3.
After loosening the mounting bolts and nuts, then remove the rear seat frame assembly (B).
Tightening torque :
Bolts : 16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
Nuts : 12.7 ~ 18.6 N.m (1.3 ~ 1.9 kgf.m, 9.4 ~ 13.7 lb-ft)

4.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
•
Replace any damage clips.
[Leg support replacement]
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Disconnect the connector (A).
3.
After loosening the mounting bolts and nuts, then remove the leg support (B).
Tightening torque :
Bolts : 16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
Nuts : 12.7 ~ 18.6 N.m (1.3 ~ 1.9 kgf.m, 9.4 ~ 13.7 lb-ft)

4.
Install in the reverse order of removal.
    Rear Seat Frame Assembly Components and Components Location
    Component Location 1. Rear seat frame assembly [LH]2. Rear seat frame assembly [RH] ...

    Front Seat Belt
    ...

    See also:

    Rear Door Outside Handle Repair procedures
    Replacement 1. Remove the hole plug (B). 2. After loosening the mounting bolt, then remove the rear door outside handle cover (A). Tightening torque : 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ...

    Jump starting
    Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm to yourself or damage to your vehicle or battery, follow the jump starting procedures. If in doubt, we strongly recomme ...

    CVVT Oil Control Valve (OCV) Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the OCV connector. 3. Measure resistance between the OCV terminals 1 and 2. 4. Check that the resistance is within the specifi ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com