>

Hyundai Equus: Rear Door Outside Handle Repair procedures - Rear Door - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Rear Door Outside Handle Repair procedures

Replacement
1.
Remove the hole plug (B).
2.
After loosening the mounting bolt, then remove the rear door outside handle cover (A).

Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

3.
Remove the rear door outside handle (A) by sliding it rearward.

4.
Disconnect the rear door outside handle connector (A).

5.
Install in the reverse order of removal.
   
Make sure the connector is connected properly.
Make sure the door locks/unlocks and opens/closes properly.
    Rear Door Outside Handle Components and Components Location
    Component Location 1. Rear door outside handle ...

    Body Side Molding
    ...

    See also:

    Electronic stability control (ESC)
    The Electronic Stability control (ESC) system is designed to stabilize the vehicle during cornering maneuvers. ESC checks where you are steering and where the vehicle is actually going. ESC ap ...

    Power outlet
    The power outlet is designed to provide power for mobile telephones or other devices designed to operate with vehicle electrical systems. The devices should draw less than 10 amps with the engin ...

    Fuel Pressure Sensor (FPS) Repair procedures
    Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Check the output voltage of fuel pressure sensor (FPS). Specification: Refer to “Specification” Removal 1. Tu ...

    Categories

    Hyundai Equus Manuals

    2011-2026 Copyright www.heqmanual.com