[Front Seat Front Shield Outer Cover]
| • |
Put on gloves to protect your hands. |
|
| • |
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage. |
| • |
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface. |
| • |
Take care not to bend or scratch the trim and panels. |
|
| 1. |
Using a screwdriver or remover, remove the front seat front shield outer cover (A). 
|
| 2. |
Disconnect the power seat air lumber support switch connector (A). 
|
| 3. |
Install in the reverse order of removal.
| • |
Make sure the connector is connected properly. |
| • |
Replace any damage clips. |
|
|
[Front Seat Rear Shield Outer Cover]
| • |
Put on gloves to protect your hands. |
|
| • |
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage. |
| • |
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface. |
| • |
Take care not to bend or scratch the trim and panels. |
|
| 1. |
Remove the front seat front shield outer cover.
(Refer to Front Seat - "Front Seat Shield Outer Cover") |
| 2. |
Remove the front seat lower protector (A). 
|
| 3. |
After loosening the mounting screw, then remove the front seat rear shield outer cover (A). 
|
| 4. |
Install in the reverse order of removal.
| • |
Replace any damage clips. |
|
|
Component Location
1. Front seat front shield outer cover2. Front seat rear shield outer cover
...
Component Location
1. Front seat shield inner cover
...
See also:
Engine Mounting Components and Components Location
Components
1. Engine mounting insulator2. Engine support bracket LH3. Engine support bracket RH4. Transmission mounting insulator
...
Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher
than the bottom of the wheel hub. Drive through any water slowly.
Allow adequate stopping distance because brake perfo ...
Rolling code programming
Rolling code devices which are "code-protected" and manufactured after 1996 may
be determined by the following:
Reference the device owner's manual for verification.
The handheld ...