>
Hyundai Equus Manuals

Hyundai Equus: Front Bumper Cover Repair procedures - Front Bumper - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Front Bumper Cover Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Front Bumper / Front Bumper Cover Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the mounting clips.

2.
After loosening the mounting clips, then remove the engine room side cover (A).

3.
After loosening the mounting clips, then remove the radiator grill upper guide (A).

4.
Loosen the front bumper upper mounting clips and bolts.

5.
After loosening the front bumper side's mounting screw, then disconnect the side's.
   
•
Remove the front bumper by pulling up the side of the front bumper and then pull it out.
   
•
When you pull out the front bumper, the side part of the front bumper could be damaged by the projection.

6.
Disconnect the front bumper main connector (A).

7.
Disconnect the fog lamp connector (A).

8.
Remove the front bumper cover (A).

9.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
•
Replace any damage clips.
    Front Bumper Cover Components and Components Location
    Component Location 1. Front bumper cover ...

    Radiator Grill Components and Components Location
    Component Location 1. Radiator grill ...

    See also:

    Troubleshooting
    Troubleshooting Trouble SymptomProbable causeRemedyVehicle pulls to one sideScoring of driveshaft ball jointReplaceWear, rattle or scoring of wheel bearingReplaceDefective front suspension and st ...

    6 Speed Clutch Control Solenoid Valve Specifications
    Specifications Direct control VFS[6/C] x Control type : Normal low type Control Pressure kpa (kgf/cmx, psi)0~1569.06 (0~16,0~227.57)Current value(mA)0~1100 Internal resistance( ...

    Components and Components Location
    Component Location 1 . Front PAS sensor (4EA)2 . Rear PAS sensor (4EA)3. Indicator (warning information displayed on LCD)4 . Parking Assist System (PAS) switch5 . Body Control Module (BCM)6. Clus ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com