>
Replacement |
|
|
1. |
Remove the caps (A) and screws, then remove the assist handle (B). |
2. |
Install in the reverse order of removal. |
Fuel Pressure Sensor (FPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Check the output voltage of fuel pressure sensor (FPS).
Specification: Refer to “Specification”
Removal
1.
Turn i ...
Front Bumper Cover Components and Components Location
Component Location
1. Front bumper cover
...
4&OD Clutch Control Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...