>
Hyundai Equus Manuals

Hyundai Equus: Cluster Fascia Panel Repair procedures - Crash Pad - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Cluster Fascia Panel Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Crash Pad / Cluster Fascia Panel Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the center fascia upper panel (A).

2.
Install in the reverse order of removal.
   
•
Replace any damage clips.
    Cluster Fascia Panel Components and Components Location
    Component Location 1. Cluster fascia panel ...

    Center Fascia Panel Components and Components Location
    Component Location 1. Center fascia upper panel2. Center fascia lower panel ...

    See also:

    Cowl Side Trim Components and Components Location
    Component Location 1. Cowl side trim ...

    Brake Booster Repair procedures
    Brake Booster Operating Test For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop it. If the pedal depress ...

    Front / Rear Parking Assist System Control Unit Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the BCM unit. (Refer to Body Control Module - "Body Control Module") Installation 1. Install the BCM unit. 2. Conne ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com