>
Replacement |
1. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim") |
2. |
Disconnect the rear door inside handle lamp connector (A). |
3. |
After loosening the mounting screws, then remove the rear door inside handle (B). |
4. |
Install in the reverse order of removal.
|
Power Window Motor Repair procedures
Inspection
Front Power Window Motor
1.
Remove (-) negative battery terminal.
2.
Remove the front door trim.
(Refer to Body - "Front Door")
3.
Disconnect the motor connector from the mot ...
Smart key precautions
The smart key will not work if any of the following occur:
- The smart key is close to a radio transmitter such as a radio station or an
airport which can interfere with normal operation of th ...
Fuel Pump Control Module (FPCM) Schematic Diagrams
Circuit Diagram
...