>
OFF
To turn off the engine, press the Engine Start/Stop Button with the Engine Start/Stop Button in the ON position and the shift lever in P(Park). When you press the Engine Start/Stop Button without the shift lever in P(Park), the Engine Start/Stop Button does not turn to the OFF position, but turns to the ACC position.
✽ NOTICE
When you turn off the engine, the vehicle should be stopped.
WARNING - Emergency situation
In an emergency situation while the vehicle is in motion, you are able to turn the engine off and to the ACC position by pressing the Engine Start/Stop Button for more than 2 seconds or 3 times successively within 3 seconds. If the vehicle is still moving, you can restart the engine without depressing the brake pedal by pressing the Engine Start/Stop Button with the shift lever in the N (Neutral) position.
ACC(Accessory)
Press the Engine Start/Stop Button when the button is in the OFF position without depressing the brake pedal.
The electrical accessories are operative. If you leave the Engine Start/Stop Button in the ACC position for more than 1 hour, the battery power will turn off automatically to prevent the battery from discharging.
ON
Press the Engine Start/Stop Button while it is in the ACC position without depressing the brake pedal.
The warning lights can be checked before the engine is started. Do not leave in the ON position for a long time if the engine is not running to prevent battery discharge.
START
To start the engine, press the brake pedal and press the Engine Start/Stop Button with the shift lever in the P(Park) or the N(Neutral) position.
For your safety, start the engine with the shift lever in the P(Park) position.
✽ NOTICE
WARNING
In-car Sensor Description and Operation
Description
An in-car air temperature sensor is located in the heater control.
The sensor contains a thermistor which measures the
temperature of the cabin. The signal determined by the resistan ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Alternator Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the engine cover.
3.
Remove the air cleaner assembly.
(1)
Remove the air duct (A).
(2)
D ...