>

Hyundai Equus: Curtain Airbag (CAB) Module Repair procedures - Airbag Module - Restraint - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Curtain Airbag (CAB) Module Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
2.
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
3.
Disconnect the curtain airbag harness connector.

4.
After loosening the mounting bolts remove the curtain airbag.

Installation
1.
Turn the ignition switch OFF.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Tighten the curtain airbag mounting bolts.

Tightening torque :
11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.9 lb-ft)

   
Never twist the airbag module when installing it. If the module is twisted, the airbag module may operate abnormally.
4.
Connect the curtain airbag connector.
5.
Install the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
6.
Reconnect the battery negative cable.
7.
After installing the curtain airbag (CAB), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.
    Curtain Airbag (CAB) Module Components and Components Location
    Components ...

    Knee Airbag (KAB) Module Description and Operation
    Description The Knee Airbag (KAB) is installed inside the crash pad lower panel and protects the driver in the event of a frontal crash. The SRSCM determines if and when to deploy the KAB. ...

    See also:

    Operating Door Locks From Outside the Vehicle
    To lock the doors, press the button on the outside door handle while carrying the Smart Key with you or press the Door Lock button on the Smart Key. Put your hand in the driver’s outside door h ...

    Rain Sensor Schematic Diagrams
    Circuit Diagram ...

    Fuel Pressure Control Valve Schematic Diagrams
    Circuit Diagram ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com