Hyundai Equus: Blind Spot Detection Switch Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Blind Spot Detecation system / Blind Spot Detection Switch Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Blind Spot Detecation system / Blind Spot Detection Switch Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery. |
| 2. |
Remove the crash pad lower panel (A).
(Refer to Body - "Crash Pad Lower Panel") |
| 3. |
Remove the crash pad lower panel and then push the blind spot detection switch (A) to remove it.
|
| Installation |
| 1. |
Install the blind spot detection switch after connecting the connector. |
| 2. |
Install the crash pad lower panel. |
| Inspection |
| 1. |
Disconnect the BSD switch connector.
|
| 2. |
Operate the BSD switch, then check for continuity between terminals of BSD switch connector.
|
See also:
LCD Display Control
The LCD display modes can be changed by using the control buttons on the steering
wheel.
1) button : Changing LCD modes
(right to left), or returning to previous position
(2) but ...
Assist Handle Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply p ...
Cylinder Block Components and Components Location
Components
1. Cylinder block bank cover2. Cylinder block bank cover gasket3. Cylinder block rear cover4. Cylinder block rear cover gasket5. Separator6. Drain plug7. O-ring8. Piston oil jet9. Chec ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com