>

Hyundai Equus: Alternator Description and Operation - Charging System - Engine Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Alternator Description and Operation

Description
The Alternator has eight built-in diodes, each rectifying AC current to DC current.
Therefore, DC current appears at alternator "B" terminal.
In addition, the charging voltage of this alternator is regulated by the battery voltage detection system.
The alternator is regulated by the battery voltage detection system.
The main components of the alternator are the rotor, stator, rectifier, capacitor brushes, bearings and V-ribbed belt pulley.
The brush holder contains a built-in electronic voltage regulator.

1. Brush
2. Drive belt pulley
3. Rotor
4. Stator

    Repair procedures
    On-vehicle Inpection     • First of all, check for DTCs. If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DTC guide) ...

    Alternator Specifications
    Specification ItemSpecificationRated voltage13.5V , 180ASpeed in use1,000 ~ 18,000rpmVoltage regulatorIC Regulator built in type Regulator reform mode voltage (V) [COM terminal]13.85 ~ 14.85 (-35 ...

    See also:

    Canister Close Valve (CCV) Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the CCV connector. 3. Measure resistance between the CCV terminal 1 and 2. 4. Check that the resistance is within the specific ...

    Components and Components Location
    Component Location Index Engine Room 1. Receiver-drier2. Condenser3. Ambient Temperature Sensor4. Compressor5. Discharge Hose6. Suction & Liquid Tube Assembly7. Service Port (Low Pressure)8. ...

    Power Window Motor Repair procedures
    Inspection Front Power Window Motor 1. Remove (-) negative battery terminal. 2. Remove the front door trim. (Refer to Body - "Front Door") 3. Disconnect the motor connector from the mot ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com