Hyundai Equus: Accelerator Pedal Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Fuel Delivery System / Accelerator Pedal Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Fuel Delivery System / Accelerator Pedal Repair procedures
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the negative (-) battery cable. |
| 2. |
Disconnect the accelerator position sensor connector (A). |
| 3. |
Disconnect the accelerator control connector (B). |
| 4. |
Remove the accelerator pedal in the direction of "Removal direction" in the figure after removing the installation bolt (B).
|
| Installation |
| 1. |
Install in the reverse order of removal.
|
Accelerator Pedal Description and Operation
Accelerator Pedal
Intelligent Accelerator Pedal (IAP) communicates with various modules by CAN communication.
IAP alarm the driver with foot power control and the vibration.Operation
...
Delivery Pipe Repair procedures
Removal
In case of removing the high pressure fuel pump, high
pressure fuel pipe, delivery pipe, and injector, there may be injury
caused by leakage of the high pressure f ...
See also:
Knock Sensor (KS) Schematic Diagrams
Circuit Diagram
...
Side impact air bag
Your vehicle is equipped with a side impact air bag in each front and outboard
rear seat. The purpose of the air bag is to provide the vehicle's driver and/or
the front and outboard rear pas ...
ON/OFF Solenoid Valve Specifications
Specifications
ON/OFF Solenoid Valve
x Control type : Normal low type
Control pressure kpa (kgf/cmx, psi)539.36(5.5, 78.23) Internal resistance(x)10~11
...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com