>
WARNING - Ashtray use
Front
To open the cover, press the cover and it will slowly open. To clean the ashtray, the plastic receptacle should be removed by lifting the plastic ashtray receptacle upward and pulling it out.
Rear
Use the rear ashtray after spreading the cover (1).
To clean the ashtray, the plastic receptacle should be removed by lifting the plastic ashtray receptacle upward and pulling it out.
Damper Clutch Control Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resi ...
SRS Control Module (SRSCM) Repair procedures
Removal
1.
Turn the engine OFF.
2.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
3.
Remove the floor console assembly.
(Refer to Body - ...
Heated Oxygen Sensor (HO2S) Description and Operation
Description
Heated Oxygen Sensor (HO2S) consists of zirconium and alumina
and is installed both upstream and downstream of the Manifold Catalytic
Converter. The sensor output voltage varies in ...