>

Hyundai Equus: Power Steering Hose Repair procedures - Electro Hydraulic Power Steering - Steering System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Power Steering Hose Repair procedures

Replacement
-
Refer to the components illustration during removal or installation.
-
When installing, be sure to connect between hose to tube using a clamp as shown in the illustration.

-
Check all clamps for deterioration or deformation; replace with the clamps new one if necessary.
-
Add the recommended power steering fluid and bleed the power steering system.
    Power Steering Gear Box Repair procedures
    Replacement 1. Drain the power steering fluid. 2. Remove the front wheel & tire. Tightening torque : 90.0 ~ 110.0 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 80.0 lb-ft) 3. Loosen the bolt (A) ...

    Power Steering Motor Components and Components Location
    Components 1. Oil reservoir2. Gear pump3. Motor4. ECU ...

    See also:

    Air Quality Sensor (AQS) Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Connect the GDS. 3. Check the output voltage of AQS between terminal 2 and 3. 1. DC 12V( Ignition)2. Sensor ground3. AQS signal Specif ...

    Front Bumper Cover Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply p ...

    TPMS (Tire Pressure Monitoring System) malfunction indicator
    The TPMS malfunction indicator will illuminate after it blinks for approximately one minute when there is a problem with the Tire Pressure Monitoring System. Have the system checked by an authori ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com