>
Hyundai Equus Manuals

Hyundai Equus: Hood Lift Repair procedures - Hood - Body (Interior and Exterior) - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: Hood Lift Repair procedures

Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Body (Interior and Exterior) / Hood / Hood Lift Repair procedures

Replacement
   
•
When removing and installing the hood lifter, an assistant is necessary.
•
When removing the clips, use a clip remover.
1.
Using a screwdriver (A), lift the socket clips (B) up slightly on both ends of the lifter and then remove the lifter from the bracket.

2.
Push the socket of the lifter into the bracket for installation.
   
•
Make sure the hood locks/unlocks and opens/closes properly.
    Hood Assembly Repair procedures
    Replacement     • Be careful not to damage the hood and body.     • When removing and installing the hood, an assistant is necessary. • Wh ...

    Hood Insulator Pad Repair procedures
    Replacement 1. Using a clip remover, detach the clips, and remove the hood insulator pad (A).     • Be careful not to scratch the hood panel. 2. Installation is th ...

    See also:

    27 Brake Control Solenoid Valve Repair procedures
    Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

    VSM OFF Switch Schematic Diagrams
    Part Circuit Diagram ...

    Checking the coolant level
    WARNING Removing radiator cap Never attempt to remove the radiator cap while the engine is operating or hot. Doing so might lead to cooling system and engine damage and could result in ser ...

    Categories

    Hyundai Equus Manuals

    © 2011-2025 Copyright www.heqmanual.com