>
Hyundai Equus Manuals

Hyundai Equus: Roof Side Molding Repair procedures - Body Side Molding - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Roof Side Molding Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Body Side Molding / Roof Side Molding Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
1.
Using a screwdriver or remover, remove the roof side molding (A).
   
•
Always replace the roof side molding to a new one.

2.
Install in the reverse order of removal.
   
•
Replace any damaged clips.
    Body Side Molding
    ...

    Front Wheel Guard Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply p ...

    See also:

    Air Lumber Support Switch Repair procedures
    Inspection 1. Disconnect the negative(-) battery terminal. 2. Remove the shield outer cover. (Refer to Body - "Front Seat Shield Outer Cover") 3. Disconnect the power seat air lumber supp ...

    In-car Sensor Repair procedures
    Inspection 1. Turn the ignition switch ON. 2. Blow warm air into the in-car sensor air inlet. Measure the sensor resistance between 1 and 3 terminals. 1. Sensor Ground 2. Motor (-)3. Incar ...

    Compressor Schematic Diagrams
    Circuit diagram 1. Air compressor connector [Motor power connector (A)][Exhaust valve connector (B)][Temperature sensor connector (C)] 2. Air compressor terminal function [Motor power] ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com