When shift shock is occurred or parts related with the transmission are replaced, TCM learning should be performed.
In the following case, TCM learning is required.
| • |
Transmission assembly replacement |
| 1. |
TCM learning condition
| A. |
ATF temperature: 30 ~ 95°C (86 ~ 203°F) |
|
| 2. |
TCM learning procedure
| - |
Repeat the below shift pattern four times or more with stepping on the brake. 
|
| 1. |
Drive the vehicle through all gears at D range. Drive from
stop to 1st to 2nd to 3rd to 4th to 5th to 6th to 7th to 8th with
keeping fixed throttle open. |
| 2. |
Down shift from 8th to 7th, 7th to 6th, 6th to 5th, 5th to 4th, 4th to 3rd, 3rd to 2nd, 2nd to 1st. |
| 3. |
Repeat the above driving pattern four times or more.
Up-shift throttle open : 15 ~ 30% |
|
Description
Automatic transmission system relies on various measurement
data to determine the current control status and extrapolate the
necessary compensation values. These values are used to ...
See also:
A/C Pressure Transducer Description and Operation
Description
The A/C Pressure Transducer (APT) converts the pressure value
of high pressure line into voltage value after measuring it. By
converted voltage value, engine ECU controls the coolin ...
Muffler Repair procedures
Removal
1.
Disconnect the rear oxygen sensor (HO2S) connector (A) on LH and RH side.
2.
Remove the front muffler (A) on LH and RH side.
Tightening torque :
39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m ...
Vehicle break-in process
No special break-in period is needed. By following a few simple precautions for
the first 600 miles (1,000 km) you may add to the performance, economy and life
of your vehicle.
Do not race the ...
Hyundai Equus: Repair procedures
Description and Operation
Schematic Diagrams