>
Hyundai Equus: Removable towing hook (if equipped)

1.Open the trunk, and remove the towing hook from the tool case.
2.Remove the hole cover by pressing the lower part of the cover on the front or rear bumper.
3.Install the towing hook by turning it clockwise into the hole until it is fully secured.
4.Remove the towing hook and install the cover after use.
Towing service
Emergency towingComponents and Components Location
Component Location
1. Start Stop Button(SSB)2. FOB key3. Trunk open switch4. RF receiver5. Interior antenna 16. Interior antenna 27. Interior antenna 38. Trunk antenna9. Door handle & do ...
Line Pressure Control Solenoid Vale Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Repair procedures
Adjustment
Inspect Sunroof Alignment
1.
Adjust the difference between the height of the glass roof panel (A) and glass weatherstrip (B).
Standard value [mm(in.)] :
Front edge : - 0.2 (- 0.00 ...