>
Replacement |
1. |
Pull down rear door window glass by pressing the power window glass switch. |
2. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim") |
3. |
After loosening the mounting screws, then remove the rear door belt outside weatherstrip. |
4. |
Remove the rear door belt inside weatherstrip. |
5. |
Remove the door frame inner cover. |
6. |
Remove the rear channel door frame garnish. |
7. |
Loosen the rear delta lower channel (C) mounting bolts. |
8. |
Remove the glass mounting plug hole (B). |
9. |
Carefully adjust the rear door window glass (A) until you can
see the bolt, then loosen them. Separate the glass from the glass run
and carefully pull the glass out through the window slot.
|
10. |
Install in the reverse order of removal.
|
Hood Latch Repair procedures
Replacement
1.
Remove the hood latch cover (A) mounting clip.
(Refer to Engine Mechanical System - "Active Air Flap(AAF)")
2.
Loosen the hood latch (B) mounting bolts.
Tightening torque : ...
Components and Components Location
Components
1. Door module2. Window glass3. Power window motor4. Outside handle cover 5. Outside handle6. Door panel7. Door checker8. Door striker9. Outside handle pad10. Door striker cover11. Do ...
Purge Control Solenoid Valve (PCSV) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within the speci ...