>

Hyundai Equus: Rear Bumper Beam Assembly Repair procedures - Rear Bumper - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Rear Bumper Beam Assembly Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the rear bumper cover.
(Refer to Rear Bumper - "Rear Bumper Cover")
2.
Disconnect the bumper antenna connector (A).

3.
Disconnect the rear bumper joint connector mounting clip (A).

4.
Remove the mounting clips (B), then remove the rear bumper beam assembly (A) and then loosen the clips.

5.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
•
Replace any damage clips.
    Rear Bumper Beam Assembly Components and Components Location
    Component Location 1. Rear bumper beam assembly ...

    Front Seat
    ...

    See also:

    Console Armrest Components and Components Location
    Component Location [Front Console Armrest] 1. Front console armrest [Rear Console Armrest] 1. Rear console armrest ...

    Repair procedures
    Adjustment 1. After loosening the trunk lid hinge (A) mounting bolt, adjust the trunk lid by moving it up or down, or right or left. 2. Adjust the trunk lid height by turning the trunk lid ove ...

    Daytime running light
    Daytime Running Lights (DRL) can make it easier for others to see the front of your vehicle during the day. DRL can be helpful in many different driving conditions, and it is especially helpful af ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com