✽ NOTICE
- When programming a garage door opener, it is advised to park the vehicle
outside of the garage. • It is recommended that a new battery be placed in the
hand-held transmitter of the device being programmed to HomeLink® for quicker
training and accurate transmission of the radio-frequency signal.
- Some vehicles may require the ignition switch to be turned to the second
(or "accessories") position for programming and/or operation of HomeLink. •
In the event that there are still programming difficulties or questions after
following the programming steps listed below, contact HomeLink® at: www.homelink.com
or 1-800-355-3515.
The Compass can be turned ON and OFF and will remember the last state when the
ignition is cycled. To turn the display feature ON/OFF:
1. Press and release the button
within 1 second to turn the ...
To train most devices, follow these instructions:
1. For first-time programming, press and hold the two outside buttons (
,
), HomeLink® Channel 1 and Channel 3, until the indicator light begin ...
See also:
Relay Box (Passenger Compartment) Description and Operation
Description
1.
Smart Junction Box(SJB)
(1)
General function : Interior Junction Box + some functions of BCM
(2)
It controls loads with CAN communication and IPS.
(3)
IPS stands for Intel ...
Climate Control Air Filter Repair procedures
Replacement
1.
Remove the stopper (B) from the glove box (A).
2.
Disconnect the air damper (A) from the glove box (B).
3.
Remove the filter cover (A) by pressing the knob.
4.
Replace t ...
Troubleshooting
Troubleshooting
•
The battery must be in good condition and fully charged for this troubleshooting.
...