>
Hyundai Equus Manuals

Hyundai Equus: Passenger Airbag (PAB) Module Repair procedures - Airbag Module - Restraint - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Passenger Airbag (PAB) Module Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Restraint / Airbag Module / Passenger Airbag (PAB) Module Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
3.
Disconnect the passenger airbag connector (A) and remove the mounting bolts (B).

4.
Remove the crash pad.
(Refer to Body - "Main Crash Pad Assembly")
   
Replace the crash pad if damaged while PAB has deployed.
5.
Remove the mounting bolts (A) from the crash pad. Then remove the passenger airbag.

   
The removed airbag module should be stored in a clean, dry place with the airbag cushion up.
Installation
1.
Turn the ignition switch OFF.
2.
Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work.
3.
Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts (A).
Tightening torque :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

4.
Install the crash pad.
(Refer to Body - "Main Crash Pad Assembly")
5.
Tighten the passenger airbag mounting bolts (B).
Connect the passenger airbag harness connector (A) to the SRS main harness connector.
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-.ft)

6.
Reinstall the glove box housing.
(Refer to Body - "Glove Box Housing")
7.
Reconnect the battery negative cable.
8.
After installing the passenger airbag, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.
    Passenger Airbag (PAB) Module Components and Components Location
    Components ...

    Side Airbag (SAB) Module Description and Operation
    Description The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when a side crash occurs. The SRSCM determines deployment of the side ai ...

    See also:

    Multi-view Camera Unit Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower pannel. (Refer to Body - "Crash Pad Lower Pannel") 3. Remove the Multi-view Camera unit (A) after di ...

    Steering Wheel Remote Controller (SWRC) Components and Components Location
    Components 1. Left Top Remote Control Switch (Audio)2. Right Top Remote Control Switch (Haptic)3. Left Bottom Remote Control Switch (Bluetooth+LDWS+Mute)4. Right Bottom Remote Control Switch (Cru ...

    G Sensor Description and Operation
    Description There are a total of 3 acceleration sensors in the vehicle that measure vehicle acceleration and communicate with the ECS ECU. The ECS ECU calculates the vertical vibration speed, ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com