>

Hyundai Equus: Parking Assist Sensor Repair procedures - Front / Rear Parking Assist System - Body Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Parking Assist Sensor Repair procedures

Removal
[Front Bumper]
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the connector from the front bumper cover.
(Refer to Body - "Front Bumper Cover")
3.
Pull out the sensor (A) by opening the sensor holder out.

4.
Disconnect the connector from the sensor.
[Rear Bumepr]
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the connector from the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
3.
Pull out the sensor (A) by opening the sensor holder out.

4.
Disconnect the connector from the sensor.
Installation
[Front Bumper]
1.
Install the senosr after connecting the connector.
2.
Connect the negative (-) battery terminal.
[Rear Bumepr]
1.
Install the senosr after connecting the connector.
2.
Connect the negative (-) battery terminal.
    Parking Assist Sensor Schematic Diagrams
    Circuit diagram ...

    Buzzer Description and Operation
    Description Buzzer ouput the warning sound of PAS. PAS output the buzzer sound and warning sound. Cluster speaker makes buzzer sound, but externer AV AMP makes warning sound. ...

    See also:

    Exhaust Manifold Components and Components Location
    Components 1. Exhaust manifold heat protector2. Exhaust manifold3. Exhaust manifold gasket4. Exhaust manifold stay ...

    Engine overheat
    If your temperature gauge indicates overheating, you experience a loss of power, or hear loud pinging or knocking, the engine is probably too hot. If this happens, you should: 1.Pull off the road ...

    ESP OFF Switch Repair procedures
    Inspection 1. Turn ignition switch OFF and disconnect the negative (-) battery cable 2. Remove the crash pad side cover. 3. Remove the lower panel. (Refer to Body - "Crash Pad") 4. Re ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com