>
Inspection |
1. |
Check signal waveform of output speed sensor using the GDS.
|
Fuel Pressure Control Valve Description and Operation
Description
Fuel Pressure Control Valve is installed on the high pressure
fuel pump and controls fuel flow flowing into the injectors in
accordance with the ECM signal calculated based on vario ...
Rear Driveshaft (VL-VL TYPE) Repair procedures
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub.
Be carefu ...
Engine overheat
If your temperature gauge indicates overheating, you experience a loss of power,
or hear loud pinging or knocking, the engine is probably too hot. If this happens,
you should:
1.Pull off the road ...