>

Hyundai Equus: Knock Sensor (KS) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Knock Sensor (KS) Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the intake manifold (Refer to “Intake And Exhaust System� in EM group).
3.
Disconnect the knock sensor connector (A).
[Bank 1]

[Bank 2]

4.
Remove the cross over fuel pipe (A).

5.
Remove the installation bolt (A), and then remove the sensor from the cylinder block.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Install in the reverse order of removal.

Knock sensor installation bolt:
14.7 ~ 24.5 N.m (1.5 ~ 2.5 kgf.m, 10.9 ~ 18.1 lb-ft)

    Knock Sensor (KS) Schematic Diagrams
    Circuit Diagram ...

    Heated Oxygen Sensor (HO2S) Description and Operation
    Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in ...

    See also:

    Front Seat Cushion Cover Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply p ...

    Specifications
    Specifications ItemsSpecificationHoodTypeRear hinged, gas lifter typeFront DoorConstructionFront hinged, full door constructionRegulator systemWire drum typeLocking systemPin-fork systemRear Door ...

    Sunroof Glass Repair procedures
    Replacement     • Put on glove to protect your hands. 1. Remove both sides of the decoration cover (A). 2. Loosen the mounting screws, then remove the glass (A) by ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com