Hyundai Equus: In-car Sensor Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / In-car Sensor Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / In-car Sensor Description and Operation
| Description |
An in-car air temperature sensor is located in the heater control.
The sensor contains a thermistor which measures the
temperature of the cabin. The signal determined by the resistance value
which changes in accordance with perceived inside temperature, is
delivered to the heater control unit and according to this signal the
control unit regulates the in-car temperature to the intended value.
Evaporator Temperature Sensor Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the evaporator temperature sensor connector.
3.
Measure the resistance between terminal “+” and “-” of the evaporator temp ...
In-car Sensor Repair procedures
Inspection
1.
Turn the ignition switch ON.
2.
Blow warm air into the in-car sensor air inlet. Measure the sensor resistance between 1 and 3 terminals.
1. Sensor Ground 2. Motor (-)3. Incar ...
See also:
Propeller Shaft Repair procedures
Inspection
CV Joint and Boots
1.
Shift the transaxle to Neutral.
2.
Raise the vehicle off the ground, and support it with safety stands in the proper locations.
3.
Check the center beari ...
ECU Schematic Diagrams
Circuit diagram
1.
ECU Connector
2.
ECU Terminal function
TerminalFunction1Ground2Ground3IGN4Battery5Battery6-7-8-9-10-11-12Reverse Valve 1x(M1 Low Side)13Ambiance Valve14Reverse Valve 2x( ...
Brake fluid
Check brake fluid level in the brake fluid reservoir. The level should be between
“MIN” and “MAX” marks on the side of the reservoir. Use only hydraulic brake fluid
conforming to DOT 3 or ...
Categories
Hyundai Equus Manuals
2011-2026 Copyright www.heqmanual.com