>
Hyundai Equus: Immobilizer system
The immobilizer system protects your vehicle from theft. If an improperly coded key (or other device) is used, the engine’s fuel system is disabled.
When the Engine Start/Stop Button is in the ON position, the Immobilizer System indicator should come on briefly, then go off. If the indicator starts to blink, the system does not recognize the coding of the Smart Key.
Press the Engine Start/Stop Button to the OFF position, then press the Engine Start/Stop Button to the ON position again.
The system may not recognize your Smart Key’s coding if another immobilizer key or other metal object (i.e., key chain) is near the Smart Key.The engine may not start because the metal may interrupt the transponder signal from transmitting normally.
If the system repeatedly does not recognize the coding of the Smart Key, contact your EQUUS dealer.
Do not attempt to alter this system or add other devices to it. Electrical problems could result that may make your vehicle inoperable.
✽ NOTICE
ALWAYS take the Smart Key with you when you leave the vehicle.
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
✽ NOTICE
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the device.
Record your key number
Restrictions in Handling KeysFront Upper Arm Repair procedures
Removal
1.
Remove the front wheel and tire (A) from front hub .
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
•
Be careful not to dama ...
Multimedia system
✽ NOTICE
If you install an aftermarket HID head lamp, your vehicle’s audio and
electronic device may malfunction.
Prevent chemicals such as perfume, cosmetic oil, sun cream, hand cle ...
Heater Core Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater -"Heater Unit")
3.
Remove the heater core cover (A) after loosening ...