>

Hyundai Equus: Front Seat Belt Pretensioner Repair procedures - Front Seat Belt - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Front Seat Belt Pretensioner Repair procedures

Replacement
   
•
When installing the belt, make sure not to damage the pretensioner.
1.
Remove the safety belt (A) by turning it in the direction of arrow using a flat-head screwdriver.

2.
Remove the center pillar lower trim.
(Refer to Interior Trim - "Center Pillar Trim")
3.
Remove the center pillar upper trim.
(Refer to Interior Trim - "Center Pillar Trim")
4.
After loosening the mounting bolt, then remove the front seat belt lower anchor (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

5.
Loosen the front seat belt webbing guide (A) mounting bolts.

6.
After disconnecting the pretensioner connector lock pin, remove the front seat belt pretensioner connectors (A), loosen the mounting bolts, then remove the front seat belt pretensioner (B).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

7.
Install in the reverse order of removal.
   
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips.
    Front Seat Belt Pretensioner Components and Components Location
    Component Location 1. Front seat belt pretensioner ...

    Height Adjust Components and Components Location
    Component Location 1. Height adjust ...

    See also:

    Tire traction
    Tire traction can be reduced if you drive on worn tires, tires that are improperly inflated or on slippery road surfaces. Tires should be replaced when tread wear indicators appear. To reduce the ...

    Outside Rear View Mirror Components and Components Location
    Component Location 1. Outside rear view mirror ...

    Climate Seat Unit Schematic Diagrams
    Circuit Diagram ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com