>
Hyundai Equus: ESP Control Unit Repair procedures
| Removal |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable |
| 2. |
Remove the Engine room junction box after removing the cover.
|
| 3. |
Disconnect the brake tubes from the HECU by unlocking the nuts counterclockwise with a spanner.
|
| 4. |
Pull up the lock (A) of the ESP control unit connector, then disconnect the connector.
|
| 5. |
Loosen the 3 ESP HECU bracket bolts, then remove HECU and bracket.
|
| 6. |
Remove the 3 bolts, then remove the bracket from HECU.
|
| Installation |
| 1. |
Installation is the reverse of removal. |
ESP Control Unit Components and Components Location
Front Wheel Speed Sensor Components and Components LocationConsole Armrest Components and Components Location
Component Location
[Front Console Armrest]
1. Front console armrest
[Rear Console Armrest]
1. Rear console armrest
...
Roof Trim Assembly Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply pr ...
TPMS Receiver Description and Operation
Description
1.
Mode
(1)
Virgin State
A.
The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state.
B.
In this state, there is no Auto-Lo ...