>
Hyundai Equus: Brake Switch Repair procedures
| Removal |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
| 2. |
Remove the lower crash pad.
(Refer to the Body - "Crash Pad") |
| 3. |
Disconnect the stop lamp switch connector (A).
|
| 4. |
Pull the locking plate (A) as indicated by the arrow.
|
| 5. |
Turn stop lamp switch 45° counterclockwise and remove it.
|
| 6. |
Remove the stop lamp switch. |
| Installation |
| 1. |
Fix the brake pedal arm and insert fully the stop lamp switch as hiding contact part.
|
| 2. |
After inserting, turn the stop switch (A) 45° clockwise, and then assemble locking plate (B) by pushing.
|
| 3. |
Confirm the gap between stop lamp switch and bracket.
|
| 4. |
Connect the stop lamp switch connector.
|
| 5. |
Install the lower crash pad.
(Refer to the Body - "Crash Pad") |
Rear Disc Brake Repair proceduresGeneral Information
General Troubleshooting Information
Before Troubleshooting
1.
Check applicable fuses in the appropriate fuse/relay box.
2.
Using the battery checker (MCR-570 KIT), check the battery for damag ...
Rail Pressure Sensor (RPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
ConditionOutput Voltage (V)Idle Approx. 1.21, ...
Start-Up
You can start the engine without inserting the key. For detailed information
refer to the Engine Start/Stop Button in section 5.
CAUTION
To prevent damaging the Smart Key :
Keep the Smart Key ...