>
Hyundai Equus Manuals

Hyundai Equus: Brake Pedal Repair procedures - Brake System - Brake System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Brake Pedal Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Brake System / Brake System / Brake Pedal Repair procedures

Removal
1.
Remove the lower crash pad.
(Refer to Body - "Crash Pad")
2.
Disconnect the stop lamp switch connector (A).

3.
Remove the mounting bracket nut (B).
Tightening torque :
14.7 ~ 21.6 N.m (1.5 ~ 2.2 kgf.m, 10.9 ~ 15.9 lb-ft)
4.
Remove the snap pin (A) and clevis pin (B).

5.
Remove the brake pedal member assembly mounting nuts (C) and then remove the brake pedal assembly.
Tightening torque :
14.7 ~ 21.6 N.m (1.5 ~ 2.2 kgf.m, 10.9 ~ 15.9 lb-ft)

Inspection
1.
Check the bushing for wear.
2.
Check the brake pedal for bending or twisting.
3.
Check the brake pedal return spring for damage.
4.
Check the stop lamp switch.
(1)
Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in and when it is released.
(2)
The stop lamp switch is in good condition if there is no continuity when plunger(A) is pushed.

    Brake Pedal Components and Components Location
    Components 1. Brake pedal member assembly2. Stop lamp switch3. Clevis pin 4. Snap pin5. Brake pedal 6. Return spring7. Bolt ...

    Front Disc Brake Components and Components Location
    Components 1. Caliper body2. Guide pin3. Locking pin4. Brake pad5. Pad shim6. Retraction spring7. Bleed screw ...

    See also:

    Schematic Diagrams
    Circuit Diagram Multi-view Camera System Input/Output 1. Camera input ItemSpecificationLens angle of view190 degreesAngle of viewHorizontal186 degreesVertical135 degreesFunctionProvides ...

    Thermostat Repair procedures
    Removal and Installation 1. Disconnect the negative terminal (A) from the battery. Tightening torque : 4.0~6.0N.m (0.4~0.6kgf.m, 3.0~4.4lb-ft) 2. Remove the air duct, air intak hose and ...

    35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures
    Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com